|
For
Sale: 37' Repco Commercial Lobster Boat
This
1982 Repco has a white gel coat finish with blue bottom paint
and a black boot stripe. The hull is solid glass and has wooden
spray rails. The stern is closed but has a tuna door. There
are 2 thru hull fittings, one for the engine and the other
for the deck hose.
The engine
is 435hp Volvo was new in 2000. It has 2,930 original hours.
There is a dry exhaust exiting the boat through the wheel
house. The engine is soft mounted to steel beams.
The running
gear shaft is 2” x 12’ stainless and has a shaft
saver. The stuffing box is a DSS and a cutlass is on the outside.
The prop is 4 bladed and made of bronze. The skeg is fiberglass
and the rudder is stainless steel.
-
Year: 1982
- Current
Price: US$ 49,900
- Located
in Cushing, ME
- Hull
Material: Fiberglass
- Engine/Fuel
Type: Single Diesel
- YW#
74591-1800670
Running
Information
1200rpm/80psi.eng/275psi.trans/8kts/low sound/temp stable
1900rpm/90psi.eng/275psi.trans/11.2kts/low sound/temp stable
2500rpm/90psi.eng/290psi.trans/18kts/low sound/temp stable
The deck surface is fiberglass and has two hatches. A fiberglass
hatch covers the stuffing box and an aluminum hatch over
the rudder. The fuel tanks are located outside of the longitudinals
apox. mid ship. Fuel capacity: 2 X 80gal.
Measurements
Aft of wheelhouse to stern: 16’
Wash rail: 13”O/D 9” I/D
Stern deck: 14’4”
Inside freeboard: 25”
The wheel house is a custom stick built structure made of
wood and fiberglass. The interior is resin over wood with
a paint finish. The windows are safety glass with wood frame.
The steering station is on the starboard and has a bronze
spindle wheel mounted on a bronze back plate. The steering
is a single ram, power hydraulic steering system with a
5 gal stainless steel reservoir. The engine controls are
Morse and there is a single bus heater.
- Bulkhead
to stern: 20’10”
- Bulkhead
depth: 26”
- Head
room at helm: 6’5”
- Bulkhead
height at helm:44”
- Bulkhead
to back of wheelhouse: 5’
Pot
Hauler
The hauler is a 12” hydro slave with an aluminum backing
plate and steel shives. The traditional stainless davit
comes with a #5 block.
Electronics
-
Auto pilot: Robertsons
- Radar:
Furuno 24mi
- Sounder:
Furuno
- Compass:
Danforth
- Chart
Plotter: Hondex (2 yrs old)VHF: Sitex
Electrical
This boat has a 12v system with 2 4D batteries. The battery
switch is made by Perko. The breaker panel has 5 switches.
Safety
Equipment
-
Epirb-battery good till 10/08
- 3
life jackets
- life
ring
- Elliot
6-man liferaft
- offshore
flares good till 2010
Fishing
Equipment
- Stainless
steel cage b
-
Aluminum tuna pulpit
- 2
rod holders
- Aluminum
tower/mast with steering controls
-
Hot tank
Pumps
The is one bilge pump located at the stuffing box. There
is also a high water alarm and float switch.
For further information please contact Mike to look at the
boat at (207)354-6077.
|